Tiger Performance Products - aviation helmets, aviation headsets, marine headsets, marine helmets, marine intercoms, marine communications, flight helmets, pilot helmets, flight helmet, aviation headset, aviation helmet, pilot helmet, helicopter helmet, helmet headsets, helicopter helmets, helicopter fight helmet, gallet helmets, msa gallet, msa gallet helmet, msa gallet helmets

View Shopping Cart
*prices subject to change without notice due to manufactures' price or EURO exchange rate changes.

TIGER CLAMSHELL SCUBA TANK CLAMPS
	The clamshell clamp is the most advanced and the most functional cylinder clamp on the market. Designed for ease of use and the ability to position bottles in difficult access areas, this clamp also has the added advantage of supporting the cylinder when undone. Made from the finest aluminum alloy and polished to a mirror finish. Features • Load spreading jaws reduce point loading of the cylinder. • Lightweight, compact design. • Higher clamping area allows more secure clamping • Easy to install with through hole access. • No tools required to remove the cylinder. • Compliance in the design allows variation in bottle size or linear misalignment during fitting. • Hand tightening knob or nylock locknut and washer for anti-vibration. • Polished aluminum backer plate and mounting hardware included. • Can be used vertically as well as horizontally • When horizontal the clamp will support the cylinder when the clamps are opened.

Applications: • SCUBA cylinders • Nitrous bottles • Fire extinguishers • Dry sump tanks		• Inline oil filters • Spinnaker booms • SBA strainers • Exhaust systems • Drive shaft guards

T-1402-3.2	6.0 CU FT. SCUBA Tank Clamp	$200.00/PR.
T-1402-4.38	13.3 & 19.9 CU. FT. SCUBA Tank Clamp	$215.00/PR.
T-1402-5.25	30 & 40 CU. FT. SCUBA Tank Clamp	$230.00/PR.
T-1402-7.25	63, 80, & 100 CU. FT. SCUBA Tank Clamp	$420.00/PR.
** Custom Sizes can be made to order-Call for Quote
Fitting and Use of your Clamshell Clamp This design allows for replacement of the nylock nut once it has worn. If required a nylock nut and washer can be used instead of the hand tightening knob to get higher clamping loads, but be careful not to over tighten the nut since it may damage the cylinder. Two ¼” mounting holes are machined in the base. We recommend that when mounting the cylinder in a horizontal plane that you have the fixed jaw underneath so it supports the cylinder when the clamp is undone. When mounting a pair of clamshell clamps on a cylinder, first mark your drilling positions with the clamps and cylinder in place.